O.1
|
Scope and application of measurement equipment specifications covered in the O-series Recommendations
�
|
O.3
|
Climatic conditions and relevant tests for measuring equipment
�
|
O.6
|
1020 Hz reference test frequency
�
|
O.9
|
Measuring arrangements to assess the degree of unbalance about earth
�
|
O.11
|
Maintenance access lines
�
|
O.22
|
CCITT automatic transmission measuring and signalling testing equipment ATME No. 2
�
|
O.25
|
[Withdrawn] Semiautomatic in-circuit echo suppressor testing system (ESTS)
�
Deleted after its content became technically out of date
|
O.27
|
In-station echo canceller test equipment
�
|
O.31
|
[Withdrawn] Automatic measuring equipment for sound-programme circuits
�
Deleted after its content became technically out of date
|
O.32
|
[Withdrawn] Automatic measuring equipment for stereophonic pairs of sound-programme circuits
�
Deleted after its content became technically out of date
|
O.33
|
Automatic equipment for rapidly measuring stereophonic pairs and monophonic sound-programme circuits, links and connections
�
|
O.41
|
Psophometer for use on telephone-type circuits
�
This Recommendation is also included but not published in P series under alias number P.53
|
O.42
|
Equipment to measure non-linear distortion using the 4-tone intermodulation method
�
|
O.51
|
[Withdrawn] Volume meters
�
O.51 was an alias name of ITU-T P.52. Only this alias name was suppressed. ITU-T P.52 remains valid
|
O.61
|
Simple equipment to measure interruptions on telephone-type circuits
�
|
O.62
|
Sophisticated equipment to measure interruptions on telephone-type circuits
�
|
O.71
|
Impulsive noise measuring equipment for telephone-type circuits
�
This Recommendation is also included but not published in V series under alias number V.55
|
O.72
|
[Withdrawn] Characteristics of an impulsive-noise measuring instrument for wideband data transmission
�
ITU-T O.72 was withdrawn on 1998-06-18.
|
O.81
|
Group-delay measuring equipment for telephone-type circuits
�
|
O.82
|
Group-delay measuring equipment for the range 5 to 600 kHz
�
|
O.91
|
Phase jitter measuring equipment for telephone-type circuits
�
|
O.95
|
Phase and amplitude hit counters for telephone-type circuits
�
|
O.111
|
Frequency shift measuring equipment for use on carrier channels
�
|
O.131
|
Quantizing distortion measuring equipment using a pseudo-random noise test signal
�
|
O.132
|
Quantizing distortion measuring equipment using a sinusoidal test signal
�
|
O.133
|
Equipment for measuring the performance of PCM encoders and decoders
�
|
O.150
|
General requirements for instrumentation for performance measurements on digital transmission equipment
�
|
O.151
|
Error performance measuring equipment operating at the primary rate and above
�
|
O.152
|
Error performance measuring equipment for bit rates of 64 kbit/s and N x 64 kbit/s
�
|
O.153
|
Basic parameters for the measurement of error performance at bit rates below the primary rate
�
|
O.161
|
In-service code violation monitors for digital systems
�
|
O.162
|
Equipment to perform in-service monitoring on 2048, 8448, 34 368 and 139 264 kbit/s signals
�
|
O.163
|
Equipment to perform in-service monitoring on 1544 kbit/s signals
�
|
O.171
|
Timing jitter and wander measuring equipment for digital systems which are based on the plesiochronous digital hierarchy (PDH)
�
|
O.172
|
Jitter and wander measuring equipment for digital systems which are based on the synchronous digital hierarchy (SDH)
�
|
O.173
|
Jitter measuring equipment for digital systems which are based on the optical transport network
�
|
O.174
|
Jitter and wander measuring equipment for digital systems which are based on synchronous Ethernet technology
�
|
O.175
|
Jitter measuring equipment for digital systems based on XG-PON
�
|
O.181
|
Equipment to assess error performance on STM-N interfaces
�
|
O.182
|
Equipment to assess error performance on Optical Transport Network interfaces
�
|
O.191
|
Equipment to measure the cell transfer performance of ATM connections
�
|
O.201
|
Q-factor test equipment to estimate the transmission performance of optical channels
�
|
O.211
|
Test and measurement equipment to perform tests at the IP layer
�
|
O.220
|
Framework for end-to-end QoS measurement and supervision for leased-circuit services
�
|
O.Sup3.1
|
[Withdrawn] Measuring instrument requirements - Sinusoidal signal generators and level-measuring instruments
�
This Supplement was withdrawn because its content was out of date
|
O.Sup3.2
|
[Withdrawn] Noise measuring instruments for telecommunication circuits
�
This Supplement was withdrawn because its content was out of date
|
O.Sup3.3
|
[Withdrawn] Principal characteristics of volume indicators
�
This Supplement was withdrawn because its content was out of date
|
O.Sup3.4
|
[Withdrawn] Consideration of interworking between different designs of apparatus for measuring quantizing distortion
�
This Supplement was withdrawn because its content was out of date
|
O.Sup3.6
|
[Withdrawn] Crosstalk test device for carrier-transmission on coaxial systems
�
This Supplement was attached to ITU-T Rec. O.1 (05/96) as Appendix I without further modification
|
O.Sup3.7
|
[Withdrawn] A measuring signal (multitone test signal) for fast measurement of amplitude and phase for telephone type circuits
�
This Supplement was renumbered as ITU-T Rec. O.81 Appendix I (06/98) without further modification
|
O.Sup3.8
|
[Withdrawn] Guidelines concerning the measurement of jitter
�
This Supplement was attached to ITU-T Rec. O.171 (04/97) as Appendix I without further modification
|
