�1���� Introduction and scope
�2���� References
�3���� Functions
�4���� Definitions and conventions
�5���� Commands
������� 5.1���� V.8 and V.8 bis operation controls, +A8E
������� 5.2���� Send V.8 menu signals
������� 5.3���� Send V.8 bis signal and/or message(s)
�6���� V.8 signal indications
������� 6.1���� CI signal indication, +A8I
������� 6.2���� Calling tone indication, +A8C
������� 6.3���� Answer signal indication, +A8A
������� 6.4���� V.8 negotiation complete, +A8J
������� 6.5���� V.8 menu report, +A8M
������� 6.6���� V.8 bis signal and message reporting
�7���� V.8 origination procedures
������� 7.1���� Configuration before the Dial
command
������� 7.2���� Operation after dialling is
completed
������� 7.3���� Answering signal detection
������� 7.4���� V.8 abort
������� 7.5���� CM signal generation
������� 7.6���� JM signal detection
������� 7.7���� Transition to communications
�8���� V.8 Answer procedures
������� 8.1���� Configuration before the Answer
command
������� 8.2���� Operation after the Answer command
������� 8.3���� Calling signal detection
������� 8.4���� JM signal generation
������� 8.5���� V.8 abort
������� 8.6���� Transition to communications
�9���� V.8 bis procedures
������� 9.1���� Initiation
������� 9.2���� Reception
������� 9.3���� Transmission
������� 9.4���� Termination
10���� Sample sessions
������ 10.1���� V.8 origination, connect as V.34
transmit and receive data
������ 10.2���� V.8 answer, preconfigure for
facsimile, but adaptively connect as a V.34 data modem
������ 10.3���� V.8 bis sample session, based
on Figure II.4/V.8 bis