�Introduction
1)���� Table 6.3, Timing for activation
signals
2)���� Clause 6.2.2.1, Signal Cr
3)���� Clause 6.2.2.8, Exception state
4)���� Clause 6.3.2.1, Signal Pri
5)���� Clause 6.3.2.2, Signal Pci
6)���� Clause 6.4.1, G.994.1 code point definitions
7)���� Clause 7.1.2.5.3, fbit3 = ps (power status)
8)���� Clause 9.2.7, Loss of sync word
failure (LOSW failure)
9)���� Clause 9.5.5.4, Frame check
sequence
10)���� Clause 9.5.5.7.2, Discovery
response � Message ID 129
11)���� Clause 9.5.5.7.4, Inventory
response � Message ID 130
12)���� Clause 11.4.2, Test circuit
calibration
13)���� Clause 11.4.3, Total transmit
power requirement
14)���� Clause A.3.1.3, Calibration
measurement of crosstalk generator
15)���� Clause A.4, PSD masks
16)���� Clause A.5.3.3, Wetting current
17)���� Clause B.3.2, Test set-up
definition
18)���� Clause B.3.5.2, Cable crosstalk
models
19)���� Clause B.3.5.4.1.1, Self
crosstalk profiles
20)���� Clause B.3.5.6, Measurement of
crosstalk noise margin
21)���� Clause B.4.1, Symmetric PSD
masks
22)���� Figure B.7, PSD masks for 0 dB
power backoff
23)���� Figure B.8, Nominal symmetric
PSDs for 0 dB power backoff
24)���� Clause B.4.2, Asymmetric
2.048 Mbit/s and 2.304 Mbit/s PSD masks
25)���� Figure B.9, PSD masks for 0 dB
power backoff
26)���� Clause B.5.2, Return loss
27)���� Clause B.5.3.2, Power feeding of
the STU‑R
28)���� Clause E.4, TPS-TC for aligned
DS1/fractional DS1 transport
29)���� Clause E.7, TPS-TC for aligned
European 2048 kbit/s digital structured leased line (D2048S) and
fractional
30)���� New Clause E.9.2.3, IMA using
the ATM TPS-TC (Informative)
31)���� Clause E.10.2, Dual bearer mode types
32)���� Table E.22, Supported TPS-TCs in dual
bearer mode
33)���� Appendix II � Typical
characteristics of cables
34)���� Tables II.1, II.2, II.3, II.4,
II.5, II.6 and II.7 � Parameters of cables
35)���� Appendix IV, Bibliography