�1���� Scope����������
�2���� References
�3���� Definitions
������� 3.1���� Terms defined elsewhere�������
������� 3.2���� Terms defined in this Recommendation�����������
�4���� Abbreviations and acronyms�������������
�5���� Conventions������������
�6���� Physical layer frequency performance requirements��������������
�7���� T-BC packet layer performance requirements for full timing support from
the network����������
������� 7.1���� Constant time error and dynamic time error noise generation
������� 7.2���� Noise tolerance�����������
������� 7.3 ����Noise transfer��������������
������� 7.4���� Transient response and holdover performance�������������
������� 7.5���� Interfaces������
Annex A � Telecom boundary clock and telecom slave clock
models����
Annex B � Control of the phase transient due to rearrangements in the synchronous
Ethernet network����
Annex C � Telecom time slave clock requirements����
������� C.1���� Physical layer frequency performance requirements��
������� C.2���� T-TSC packet layer performance requirements for full timing
support from the network����
Appendix I � Mitigation of time error due to SyncE/SDH transients����
Appendix II � Derivation of T-BC/T-TSC output transient mask
due to SyncE/SDH rearrangement����
������ II.1���� Background on assumptions for and derivation of T-BC output
phase error due to a SyncE/SDH rearrangement����
������ II.2���� T-BC output phase transient mask��������
Appendix III � Background to performance requirements of the
T-BC/T-TSC����
����� III.1���� Noise generation requirements������������
����� III.2���� Noise tolerance������������
����� III.3��� �Noise transfer
����� III.4���� Holdover���������
Appendix IV � Consideration on slave clocks embedded in end applications����
Appendix V � Performance Estimation for Cascaded Media Converters acting as
T-BCs����
������� V.1���� Noise generation�������
������� V.2�� ��Noise tolerance����������
������� V.3���� Noise transfer�������������
������� V.4���� Transient response and holdover performance�������������
Appendix VI � Choice of frequencies for measuring noise
transfer����
������ VI.1���� Envelope repeat
frequency���
������ VI.2���� Choice of artefact
frequency
������ VI.3���� Possible frequencies
������ VI.4���� Expected filter
response (PTP to PTP and PTP to 1 pps noise transfer)�
������ VI.5���� Expected filter
response (SyncE-to-PTP and SyncE-to-1pps noise transfer)��������
Bibliography����