Policy on Intellectual Property Right (IPR)
Annex 1� Protection criteria of radiocommunication services operating
below 30 MHz and between 80 and 470 MHz
Annex 2� Examples of national regulations
Appendix 1 to Annex 2� United States of America� Regulation of RF
emissions from power line communication systems in the United States of America
�1����
Introduction
�2����
Definition of BPL
�3����
Emission limits
�4����
Special frequency protections
������� 4.1����
Frequency band exclusions
������� 4.2
����Geographical exclusion zones
������� 4.3����
Consultation area requirements
������� 4.4����
Consultation area notice requirements
������� 4.5����
Public safety licensee notice requirements
�5����
Interference mitigation
������� 5.1����
Interference complaint procedures
������� 5.2����
Adaptive interference techniques
������� 5.3����
Access BPL database requirements
�6����
Measurement guidelines
������� 6.1����
Existing measurement requirements
������� 6.2����
New/modified measurement requirements
�7��� �Equipment
authorization
�8����
Conclusion
Appendix 2 to Annex 2� Germany
Annex 1 to ECC Recommendation (05)04� Guidelines for the assessment of
radio interference cases caused by disturbing radiations generated by wire-line
telecommunication networks
Unresolved interference
complaint
Interference resolution
Compliance investigation
Explanation of flowchart
Addendum to Annex 1 of ECC Recommendation (05)04� Explanation of
flowchart in Annex 1 to ECC Recommendation (05)04
Annex 2 to ECC Recommendation (05)04� Mitigation techniques and
considerations, including limits of the disturbance field strength, applicable
to blocks 3 and 4 of flowchart in Annex 1 to ECC Recommendation (05)04
�1����
Technical aspects
�2����
Economic and political aspects
�3����
Regulatory aspects
�4����
Assessment of all criteria and circumstances
Appendix 3 to Annex 2� Japanese regulations for the power line high data
rate� telecommunication systems
�1����
Fundamental principle
�2����
Equipment allowed to be used: In-house PLT equipment only
�3����
Limits
������� 3.1����
Conducted emission at the mains port
������� 3.2����
Conducted emission at the telecommunication port
������� 3.3����
Radiated emission
�4����
Derivation of the limits
������� 4.1����
Procedures
������� 4.2����
PLT installation model and draft limits
������� 4.3����
Japanese PLT limits
�5����
Measurement conditions for the PLT common-mode current
Appendix 4 to Annex 2� Federative Republic of Brazil� Brazilian
regulation on power line high data rate telecommunication systems
�1����
Introduction
�2����
General requirements
�3����
Measurements
�4����
Specific requirements
������� 4.1����
Frequency band exclusions
������� 4.2����
Exclusion zones
������� 4.3����
Preventive action
������� 4.4����
Coordination process
�5����
Conclusion
Appendix 5 to Annex 2� Republic of Korea
�1����
Limits
������� 1.1����
Limits for conducted emission at power ports
������� 1.2����
Limits for radiated disturbance
������� 1.3����
The prohibited frequency band as use of PLT
�2����
Measurement method of radiated disturbance
������� 2.1����
Measurement methods in frequency range 9 kHz to 30 MHz
������� 2.2����
Measurement methods in frequency range 30 MHz to 1 000 MHz