CONTENTS

Policy on Intellectual Property Right (IPR)
�1���� Introduction
������� 1.1���� Data communication over electrical power lines
�2���� Characteristics of radio frequency emission from PLT Systems
������� 2.1���� Radiation sources in a PLT system
� ����������������2.1.1���� Differential-mode and common-mode currents
����������������� 2.1.2���� Generation of the common-mode PLT current
����������������� 2.1.3���� Common-mode current launched at the PLT modem output port
����������������� 2.1.4���� Converted common-mode current
����������������� 2.1.6���� Shielding effectiveness of the exterior walls of a house
�3���� Radio system characteristics, protection criteria, and impact of PLT systems on radiocommunication systems
������� 3.1���� Broadcasting
���������������� 3.1.1���� General characteristics of analogue LF, MF and HF broadcasting
����������������� 3.1.2���� General characteristics of DRM digital LF, MF and HF broadcasting
����������������� 3.1.3���� LF, MF, HF and VHF radio broadcasting frequency ranges
����������������� 3.1.4���� Protection criteria and acceptable interference
������� 3.2���� Amateur and amateur satellite
����������������� 3.2.1���� General characteristics
����������������� 3.2.2���� Amateur frequency allocations
������������ �����3.2.3���� The protection requirements of the HF amateur radio service
������� 3.3���� Aeronautical mobile and radionavigation
����������������� 3.3.1���� Results
������� 3.4���� General protection criteria considerations HF fixed and land mobile
���� �������������3.4.1���� Protection criteria and protection requirement
����������������� 3.4.2���� A possible protection criteria
����������������� 3.4.3���� Automatic link establishment systems
������� 3.5���� Maritime mobile
����������������� 3.5.1���� Background
����������������� 3.5.2���� Frequencies allocated for maritime communications
����������������� 3.5.3���� Receiver parameters for the maritime mobile service in MF and HF bands
����������������� 3.5.4���� Hyperbolic radionavigation systems
���� �������������3.5.5���� LF/MF maritime radionavigation beacons
������� 3.6���� Radiolocation
����������������� 3.6.1���� Oceanographic radar systems in the bands 3-50 MHz
����������������� 3.6.2���� System characteristics
������� 3.7���� Fixed
������������ �����3.7.1���� Fixed system characteristics
����������������� 3.7.2���� Protection criteria
������� 3.8���� Radio astronomy
������� 3.9���� Standard frequency and time
�4���� Potential means for preventing or eliminating interference
������� 4.1���� Mitigation factors and methods for power line communications
����������������� 4.1.1���� Attenuation of conducted signals
����������������� 4.1.2���� Frequency band exclusions
����������������� 4.1.3���� Geographical exclusion zones
����������������� 4.1.4���� Consultation area requirements
����������������� 4.1.5���� Adaptive interference techniques
����������������� 4.1.6���� Interference complaint procedures
����������������� 4.1.7���� PLT operator database
������� 4.2���� Studies of mitigation techniques
��� ��������������4.2.1���� Study of mitigation techniques in Brazil
����������������� 4.2.2���� Intermodulation effects on the depth of spectrum notches in PLT systems
�5���� Overall conclusions
Annex 1� Noise, radiation and propagation considerations
A1���� Noise, radiation and propagation considerations
������ A1.1���� Noise level in the HF band
����������������� A1.1.1���� The ambient noise environment
����������������� A1.1.2���� Measuring the ambient noise floor
����������������� A1.1.3���� Determination of the noise level
������ A1.2���� Propagation mechanisms
����������������� A1.2.1���� Near-field and ground-wave propagation
����������������� A1.2.2���� Sky wave propagation
����������������� A1.2.3���� Examples of propagation calculations and studies
Annex 2� Analyses of potential interference
A2���� Analyses of potential interference
������ A2.1���� A modelling analysis for the radio astronomy service
����������������� A2.1.1���� Uses of HF bands by the RAS
����������������� A2.1.2���� Separation distances between a RA antenna and a PLT system in the HF region
a)���� Direct path calculation
b)���� Ionospheric propagation
����������������� A2.1.3���� Discussion
����������������� A2.1.4���� Conclusions
������ A2.2���� Overview of power line telecommunication systems interference to the broadcasting service
����������������� A2.2.1���� Introduction
����������������� A2.2.2���� Interference effects into low VHF television
����������������� A2.2.3���� Interference effects into the HF band
����������������� A2.2.4���� Summary and conclusions
������ A2.3���� Effects of interference from PLT into the broadcasting service below 30 MHz
������ A2.4���� Methodology for calculation of cumulative HF skywave interference from power line telecommunication systems
���� �������������A2.4.1���� Governmental skywave interference example into Winnipeg, Canada
Cumulative PLT tool execution within MATLAB is shown below:
����������������� A2.4.2���� NTIA study on ionospheric propagation and aggregation of Access PLT emissions
���������������� A2.4.3���� Results on calculation of cumulative HF sky-wave interference caused by power line telecommunication systems
�1���� Power radiated from a single PLT system
�2���� Cumulative treatment of distributed PLT systems
�3���� Calculation of the cumulative field strength distribution through HF sky-wave propagation
����������������� A2.4.4���� Compatibility study results between the radio astronomy observations in the HF band and cumulative HF sky-wave interference caused by in-house power line telecommunication systems
������ A2.5���� Experimental results of the subjective assessment test on HF analogue broadcast reception interfered with by PLT
����������������� A2.5.1���� Test methods
����������������� A2.5.2���� Test results
��������� ��������A2.5.3���� Test equipment
������ A2.6���� Compatibility analysis regarding protection requirements of HF aeronautical mobile radio in relation to PLT in-house devices
����������������� A2.6.1���� Introduction
����������������� A2.6.2���� Study assumptions
����������������� A2.6.3���� Compatibility model/geometrical computation
����������������� A2.6.4���� Evaluation threshold for the aeronautical radio
����������������� A2.6.5���� Results of the analysis
����������������� A2.6.6���� Other determinants
����������������� A2.6.7���� Requirements toward PLT devices for protecting the HF aeronautical mobile service
Annex 3� Radio frequency emissions from PLT systems
A3���� Radio frequency emissions from PLT systems
������ A3.1���� Measurement of access PLT non intentional radiated RF levels on HF bands
����������������� A3.1.1���� Introduction
����������������� A3.1.2���� Objective
����������������� A3.1.3���� Interference concept
����������������� A3.1.4���� Test description
����������������� A3.1.5���� Comments
����������������� A3.1.6���� Possible mitigation technique
����������������� A3.1.7���� Conclusions
������ A3.2���� Measurements of the radiated emissions from in-house power line telecommunications devices into the residential environment in Canada
����������������� A3.2.1���� Introduction
����������������� A3.2.2���� Conducted power measurement � Test procedure and results
����������������� A3.2.3���� Field strength measurements � Procedure and results
����������������� A3.2.4���� Conclusions
������ A3.3���� Measurement results of the radiated emissions from in-house power line telecommunications systems into the residential environment in the test conducted in Japan
����������������� A3.3.1���� Introduction
����������������� A3.3.2���� Measurement method
����������������� A3.3.3���� Condition of PLT communication
����������������� A3.3.4���� Measurement result
������ A3.4���� Measurement results of leaked emissions by access PLT system in the HF and the UHF bands
����������������� A3.4.1���� Introduction
����������������� A3.4.2���� Field experiment at Mt. Akagi, Japan, in July 23, 2002
����������������� A3.4.3���� Leaked emissions in the HF band
����������������� A3.4.4���� Spurious emission in the UHF band
����������������� A3.4.5���� Comparison of the PLT noise level with Recommendation ITU-R RA.769 at 327 MHz
����������������� A3.4.6���� Conclusions
������ A3.5���� Distance separation measurements
����������������� A3.5.1���� Distance separation measurements in Brazil
���������������� �A3.5.2���� Distance separation measurements in Canada
����������������� A3.5.3���� �Distance dependence of the leaked electric field caused by in-house PLT systems separation measurement in Japan
Appendix 1 to Annex 3� Measurements of EM radiation from in-house PLT devices operating in a residential environment � Field Test Report
Annex 4� Design examples of PLT technology
A4���� Design examples of PLT technology
������ A4.1���� Examples of a PLT network topology
������ A4.2���� General design considerations
����������������� A4.2.1���� Media access control
����������������� A4.2.2���� Repeaters
����������������� A4.2.3���� Multiplexing and multiple access approaches
����������������� A4.2.4���� Distance
������ A4.3���� PLT network architectures on MV distribution lines
������ A4.4���� PLT network architectures on low voltage distribution lines
����������������� A4.4.1���� Low density PLT network topology
����������������� A4.4.2���� High density PLT network topologies
����������� ������A4.4.3���� PLT star network topology
����������������� A4.4.4���� PLT tree network topology
����������������� A4.4.5���� PLT multi-floor network topology